Troubleshooting debugging via loopback

Here are two things you can try:

1) Firewall. It's very possible a firewall is blocking access to optiperl, so you must enable optiperl (or the system depending on the firewall) to allow aceess to port 9010 & 9020.

Note that in the windows XP included firewall, if enabled you must open these ports (see Control Panel / Internet firewall / Exceptions )

2) Try toggling the setting Debug / Redirect Input & output

3) Do the included examples work?

11.12.2004. 23:45

This article hasn't been commented yet.